Drilling Pumpwire
Paige Pumpwire Logo

Paige Submersible Pumpwire
Marine Shipboard
Offshore Pump Cables


600 Volt 3/C no Ground EPR/BLUE-NBR/PVC/TUF-HIDE
VOLTAGE:
600V
INSULATION: EPR - Ethylene Propylene Rubber
INSULATION JACKET: Blue NBR/PVC
OUTER JACKET: Clear Tuf-Hide
SIZES: 8 AWG - 2/0 AWG
TEMP DRY/WET: 90°C Dry, 75°C Wet
SCOPE: Flat submersible pump cables for use within the well casing for deep-well water pumps, off-shore applications where flexible cut resistant properties are required. Cable is integral filled to eliminate gas wicking possibilities.
APPROVALS:  UL LOGO    RoHs Logo


3C with Ground XLPO/XLCP
VOLTAGE:
600/1000V
INSULATION: XLPO - Cross-Linked Polyolefin
OUTER JACKET: XLCP - Cross-Linked Chlorosulfonated Polyethylene
SIZES: 16 AWG - 777 MCM
TEMP DRY/WET: 125°C
SCOPE: Round cable designed for use in deep well submersible in fresh or salt water suitable for continuous submersion to 984’ and temporary power supply where grounded circuits are not required.
Dual rated submersible Type W. Impact, Abrasion, Ozone, Sun, Weather, Heat, Oil, and Grease resistant.
APPROVALS:  UL LOGO   RoHs Logo    RoHs Logo    RoHs Logo    RoHs Logo   RoHs Logo    UL LOGO    UL LOGO   RoHs Logo  


3C with Ground XLPO/Bronze Armor/XLCP
VOLTAGE:
600/1000V
INSULATION: XLPO - Cross-Linked Polyolefin
OUTER JACKET: XLCP - Cross-Linked Chlorosulfonated Polyethylene
ARMOR: Bronze Interlaced Armor
SIZES: 16 - 777 AWG, 3 & 4 CONDUCTORS
TEMP DRY/WET: 125°C
SCOPE: Extra flexible armored and sheathed multi-conductor power cable. Applicable for offshore oil and gas drilling platforms, MODUs, ships and FPSOs, land-based oil and gas drilling rigs. Suitable for use in Class 1 Division 1 and Zone 1 environments. Mud and Oil resistant.
APPROVALS:  UL LOGO   RoHs Logo    RoHs Logo    RoHs Logo    RoHs Logo   RoHs Logo    UL LOGO    UL LOGO   RoHs Logo